Create an ACL to Block New TCP Sessions Using TCP Flags
How do I apply an access control list (ACL) to allow already established TCP session traffic and block new TCP sessions on an ingress port based on TCP flags?
- Cumulus Linux, all versions
This solution operates on the theory that a TCP session is established using the three-way handshake consisting of SYN, SYN-ACK, and ACK. Only SYN may exist in a new connection. ACK, FIN, and RST are not allowed in a new connection. For existing sessions, SYN may exist but only with an ACK.
By default, ACL rules for the cumulus system are coded in multiple
*.rules under the default directory
etc/cumulus/acl/policy.d. The *.rules files are processed in sorted file order. Each ACL policy rules file may contain iptables, ip6tables, and etables categories under the tags
[etables] respectively. Note that the etables category is used for layer 2 and is not used in this example.
After coding the rules, use
cl-acltool to install and sync them in hardware.
The example solution below creates rules on the INPUT and FORWARD chains to drop ingress IPv4 and IPv6 TCP packets when the SYN bit is set and the RST, ACK, and FIN bits are reset. The default for the INPUT and FORWARD chains allows all other packets. The ACL is applied to ports swp20 and swp21. After configuring this ACL, new TCP sessions that originate from ingress ports swp20 and swp21 will not be allowed. TCP sessions that originate from any other port are allowed.
Configuring the ACL Rules
/etc/cumulus/acl/policy.d/50tcp_established.rules and add the following configuration:
INGRESS_INTF = swp20,swp21 [iptables] -A INPUT,FORWARD --in-interface $INGRESS_INTF -p tcp --syn -j DROP [ip6tables] -A INPUT,FORWARD --in-interface $INGRESS_INTF -p tcp --syn -j DROP
--syn flag in the above rule will match packets with the SYN bit set and the ACK, RST, and FIN bits cleared.
It is equivalent to using
-tcp-flags SYN,RST,ACK,FIN SYN. For example, the above rule could be re-written as:
-A INPUT,FORWARD --in-interface $INGRESS_INTF -p tcp --tcp-flags SYN,RST,ACK,FIN SYN -j DROP
cl-acltool -i to install the rules. If no errors are detected, the rules will be installed and synced with the hardware. The following output indicates that the rules were successfully installed:
Reading rule file /etc/cumulus/acl/policy.d/50tcp_established.rules ... Processing rules in file /etc/cumulus/acl/policy.d/50tcp_established.rules ... Installing acl policy done.
Verifying the Rules
After installing the rules, use
cl-acltool -L all to check that the rules are present and the packet and byte counters are incrementing as expected.
Chain FORWARD (policy ACCEPT 41224 packets, 4653K bytes) pkts bytes target prot opt in out source destination 29 1856 DROP tcp -- swp20 any anywhere anywhere tcpflags: FIN,SYN,RST,ACK/SYN 0 0 DROP tcp -- swp21 any anywhere anywhere tcpflags: FIN,SYN,RST,ACK/SYN