OpenStack Neutron ML2 and Cumulus Linux
The Modular Layer 2 (ML2) plugin is a framework that allows OpenStack Networking to utilize a variety of non-vendor-specific layer 2 networking technologies. The ML2 framework simplifies adding support for new layer 2 networking technologies, requiring much less initial and ongoing effort - specifically, it enables dynamic provisioning of VLAN/VXLAN on switches in OpenStack environment instead of manually provisioning L2 connectivity for each VM.
The plugin supports configuration caching. The cached configuration is replayed back to the Cumulus Linux switch from Cumulus ML2 mechanism driver when a switch or process restart is detected.
In order to deploy OpenStack ML2 in a network with Cumulus Linux switches, you need the following:
- A REST API, which is installed in Cumulus Linux.
- The Cumulus Networks Modular Layer 2 (ML2) mechanism driver for OpenStack, which you install on the OpenStack Neutron controller node. It’s available as a Python package from upstream.
Configuring the REST API
Configure the relevant settings in
[ML2] #local_bind = 10.40.10.122 #service_node = 10.40.10.1 # Add the list of inter switch links that # need to have the vlan included on it by default # Not needed if doing Hierarchical port binding #trunk_interfaces = uplink
Restart the REST API service for the configuration changes to take effect:
cumulus@switch:~$ sudo systemctl restart restserver
Additional REST API calls have been added to support the configuration of bridge using the bridge name instead of network ID.
Installing and Configuring the Cumulus Networks Modular Layer 2 Mechanism Driver
You need to install the Cumulus Networks ML2 mechanism driver on your Neutron host, which is available upstream:
root@neutron:~# git clone https://github.com/CumulusNetworks/networking-cumulus.git root@neutron:~# cd networking-cumulus root@neutron:~# python setup.py install root@neutron:~# neutron-db-manage upgrade head
Then configure the host to use the ML2 driver:
root@neutron:~# openstack-config --set /etc/neutron/plugins/ml2/ml2_conf.ini mechanism_drivers linuxbridge,cumulus
Finally, list the Cumulus Linux switches to configure. Edit
/etc/neutron/plugins/ml2/ml2_conf.ini in a text editor and add the IP
addresses of the Cumulus Linux switches to the
switches line. For
The ML2 mechanism driver contains the following configurable parameters.
You configure them in the
switches- The list of Cumulus Linux switches connected to the Neutron host. Specify a list of IP addresses.
scheme- The scheme (for example, HTTP) for the base URL for the ML2 API.
protocol_port- The protocol port for the bast URL for the ML2 API. The default value is 8000.
sync_time- A periodic time interval for polling the Cumulus Linux switch. The default value is 30 seconds.
spf_enable- Enables/disables SPF for the bridge. The default value is False.
new_bridge- Enables/disables VLAN-aware bridge mode for the bridge configuration. The default value is False, so a traditional mode bridge is created.
A demo involving OpenStack with Cumulus Linux is available in the Cumulus Networks knowledge base. It demonstrates dynamic provisioning of VLANs using a virtual simulation of two Cumulus VX leaf switches and two CentOS 7 (RDO Project) servers; collectively they comprise an OpenStack environment.